16-years focus on manufacturing machinery equipment

Type II emulsifier

Equipment Introduction

Stable operation, low noise, easy to clean, flexible and can be used continuously. Unique set, rotor structure, high-speed line speed, produce strong shear, quickly reduce the droplet size, so that more stable emulsion, more uniform dispersion. To provide different specifications series of products, to meet different installation conditions and non-standard requirements.

Principle of equipment

High shear dispersive emulsification is the efficient, rapid, uniform distribution of one or more phases into the other continuous phase, and in general each phase is mutually incompatible. Due to the strong kinetic energy caused by the tangential velocity and angular velocity produced by the high-speed rotation of the rotor, the material is subjected to strong mechanical and hydraulic shear, centrifugal extrusion, liquid layer friction and impact in the gap between stator and rotor. Tearing and turbulence, so that the immiscible solid, liquid, gas phase in the appropriate mature technology and the right amount of additives under the action of instant uniform fine dispersion emulsification, after high-frequency cycle, and finally get stable Of high-quality products

Equipment Icon

Model Power(kW) Speed(rpm) A B C D E F n-d Applicable volume(L)
BRH-90 1.5 2900 80 140 355 165 200 615 4-φ16 10-50
BRH-100 2.2 2900 88 145 650 165 200 975 4-φ16 50-100
BRH-120 4 2900 120 180 750 215 250 1130 4-φ16 100-300
BRH-140 7.5 2900 140 210 900 265 300 1350 4-φ16 200-800
BRH-160 11 2900 160 230 1050 300 350 1600 4-φ16 300-1000
BRH-180 18.5 2900 180 260 1200 300 350 1780 4-φ20 500-1500
BRH-200 22 1480 220 270 1200 300 350 1850 4-φ20 800-2000
BRH-220 30 1480 240 320 1355 350 400 2005 8-φ20 1000-3000
BRH-240 37 1480 260 340 1395 350 400 2140 8-φ20 1500-5000
BRH-270 55 1480 290 380 1650 500 550 2520 8-φ20 2000-8000
BRH-290 75 1480 310 400 1660 500 550 2580 8-φ20 3000-10000
Note
* The upper limit of processing capacity in the table refers to the data measured when the medium is "water";
* If the medium viscosity or solid content is high, it is recommended with pipeline high shear dispersing emulsifier with the use;
* If high temperature, high pressure, flammable and explosive, corrosion and other special conditions, the need to provide detailed and accurate parameters;
* The data in this table are subject to change without notice, the correct parameters to provide the real object

Related Products

  • Hydraulic lift lift emulsifier

  • Type I emulsifier

  • Type III emulsifier

  • Four type emulsifier

  • Bottom emulsifier

  • Flow-type emulsifiersifier

  • Laboratory emulsifier

  • Hydraulic lift lift emulsifier

  • Manual lift emulsifier

  • Manual lift simple emulsifier

Copyright © Wenzhou Flowtam Light Industry Machinery Co., Ltd. All rights reserved. | Support by:YIYI | Sitemap | XML | 浙ICP备18006322号

Emulsifier and mixer | Sanitary pump series | Mixing tank series | Storage tank and fermentation tank | Colloid mill