place the device with three foot in
machine of decelerate of level and vertical, can install tube of imports
and exports, to ensure that the mixing barrel out of the air valve of
circulation, do not turn off the valve when power should pay attention
to the mixing slurry to rotate clockwise, do not reversal, heating
section, first, heat conduction oil, then through electric socket and
installation guide ground .
The use and maintenance
Description: before use, must use light hot water wash the receiver,
then use steam sterilization, add materials(do not be too full to avoid
2. Heating methods: if have temperature device, put the
thermometer in the required temperature first, then power supply source,
after using, cut the power off, then close the agitator power.
Cleaning: processing the end, put all the remaining material in
cylinder, warm water wash as soon as possible, brush off the thick paste
material,then use 10 to 50 degrees Celsius alkaline to wash the inner
wall, finally, use clean water to rinse. Available again, use hot water
or steam to keep 3 ~ 4 minutes disinfects processing.
Maintenance: pay attention to the performance of the whole equipment and
gear reducer, gear reducer lubricating oil shortage should immediately
added oil change once half a year (40 # engine oil) and pay attention to
the heat conduction oil liquid level, if the lack of heat conduction
oil to immediately stop heating, otherwise, will burn out electric
heating rods.When the device is not in use, be sure to use warm water
wash, avoid salt corrosion, often scrub the cylinder to keep the look
clean, bright interior, to achieve durable purpose.
5. After using,
cut off power supply first, then add water, to protect the electric
heat pipe or electric heating rod part.Technical parameters (stirring
speed, stirring method can change according to the needs of customers)